VR-160 OPERATING MANUAL90
APPENDIX
COMPUTER CONNECTIONS
The VR-160 allows connecting a computer USB port to the ACC Jack, and enables memory
management and configuration using the Optional ADMS-5 Advanced Data Management
System.
1. Press and hold in the
[
BANK
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 01: ACC SE-
LECT.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
BANK
]
key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select “PC PROGRAM”.
5. When you have made your selection, press and hold in the
[
BANK
]
key for one second to save the setting and exit to normal operation.
When the ACC Jack configuration is set to “PC PROGRAM”, the
“ ” icon will appear at the upper right corner of the display.
Refer to the illustration below, connect the supplied Connection Cable
of the ADMS-5 between the USB jack of your Computer and the
ACC Jack on the VR-160.
To Your Computer
(
USB Port
)
To Next Page
Loading...
Need help?
General
