A-6
Charging unit and starting unit (F150A, FL150A for European and Oceanian
markets)
1. Engine ECM
2. PTT relay
3. PTT motor
4. Starter relay
5. Starter motor
6. PTT switch
7. Trim sensor
8. Tilt limiter
9. Joint connector 1
10. Joint connector 2
11. Fuse box
12. Stator assembly
13. Rectifier Regulator
14. Battery
15. House (accessory) battery
a. Fuse (50A) (engine battery)
b. Fuse (50A) (house [accessory] battery)
c. Fuse (20A) (engine ECM, ISC valve, fuel injector, high-pressure fuel pump, ignition coil)
d. Fuse (20A) (engine start switch, PTT switch)
e. Fuse (30A) (starter relay)
f. Main relay
A. To remote control
B. To hub
D. To diagnostic flash indicator
E. To YDIS
F. To alert indicator
G. If the outboard motor is not fitted with a tilt limiter (optional), connect the coupler.
H. If the 6Y8 Multifunction Meter is selected, connect the coupler.
*1. The connecting points for the same colored wiring within the coupler can be changed.
To Next Page
Loading...
Need help?
General
