EasyManuals Logo
Home>Yamaha>Outboard Motor>F150A

Yamaha F150A Service Manual

Yamaha F150A
493 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
2-6
Electronic control system
0
1
2
3
4
5
6
7
8
9
10
A
Fail-safe control
If the electrical components malfunction, the engine ECM controls the ignition and fuel injection as
shown in the table.
*1. Control mode when the part malfunctions.
Trouble
code
Item Trouble conditions to be detected
13 Pulser coil
No signal is sent from one of two sensors 4 or more
consecutive times.
15 Engine temperature sensor
Open or short circuit in the engine temperature sensor
circuit.
Output voltage is less than 0.18 V or more than 4.93 V.
When the engine starts: Set to 5 °C (41 °F), 20 °C
(68 °F), or 40 °C (104 °F) depending on the signal
from the air temperature sensor. *1
18 TPS
Open or short circuit in the TPS circuit
Output voltage is less than 0.3 V or more than 4.7 V.
Determines the fully closed position of the throttle
based on the signal from the air pressure sensor. *1
19 Battery voltage
Voltage is less than 12 V for 2 minutes, even when
engine speed is more than 2000 r/min.
23 Air temperature sensor
Open or short circuit in the air temperature sensor
circuit.
Output voltage is less than 0.1 V or more than 4.61 V.
Set to 40 °C (104 °F). *1
28 Shift position switch
Cranking while in gear.
Cranking while the shift position circuit is open-
circuited.
29 Air pressure sensor
Open or short circuit in the air pressure sensor circuit.
Output voltage is less than 0.2 V or more than 4.5 V.
Temporarily sets air pressure levels based on the
engine speed and the TPS signal. *1
37 Intake air passage
The shift position switch is off, the throttle is fully
closed, the ISC valve is fully closed, and the engine
speed is more than 1200 r/min.
39 Oil pressure sensor
Open or short circuit in the oil pressure sensor circuit.
Output voltage is less than 0.3 V or more than 4.8 V.
45 Shift cut-off switch
Output voltage is more than 4.5 V, the switch is ON
when the engine is started, or both the shift cut-off
switch and shift position switch are ON for 5 seconds.
46 Thermoswitch Not detected
86 Immobilizer (Y-COP)
Open or short circuit in the Y-COP circuit.
Communication error continues for more than 3
seconds.

Table of Contents

Other manuals for Yamaha F150A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha F150A and is the answer not in the manual?

Yamaha F150A Specifications

General IconGeneral
BrandYamaha
ModelF150A
CategoryOutboard Motor
LanguageEnglish

Related product manuals