3-3
Uncrating
Uncrating
Uncrating procedure
Wear gloves to avoid injury by sharp steel
edges while uncrating.
1. Check the crate for shipping damage.
2. Remove the top cover.
3. Remove all of the bolts from the bottom
plate, and then remove the frame.
Be careful not to damage the outboard
motor.
4. Remove the wrapping, and then check
the outboard motor for concealed dam-
age.
5. Remove the top cowling, and then
remove the flywheel magnet cover “1”.
6. Install the lifting harnesses “1” to the
engine hangers “2”.
7. Tension the lifting harnesses.
TIP:
Place a rag “1” between the flywheel magnet
and the lifting harness.
8. Remove the skeg holder “1”.
9. Lift up the outboard motor carefully along
with the bottom frame “1”.
Make sure that the lifting harnesses do
not damage any parts of the outboard
motor.
10. Remove the bolts “1”.
1
1
2
2
1
1
1
To Next Page
Loading...
Need help?
General
