Yamaha Morphous CP250W User Manual

INSTRUMENT AND CONTROL FUNCTIONS
2
EAU15301
Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
NOTE:.
pair it if it does not function proper-
ly.
1. Open.
2. Trunk lid
2. Fold the trunk lid up.
To close the trunk
1. Fold the trunk lid down.
2. Remove the key from the lock.
NOTE:.
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See further down for an explanation of
the ignition circuit cut-off system.)
3
EWA10240
Push both sides of the lid down so that
both latches snap into place.
A WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha’s ignition circuit cut-off
ECA15301
CAUTION:
To avoid locking the key in the trunk,
never remove the key from the lock
before closing the lid.
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly as described
below and have a Yamaha dealer re-
3-15

Yamaha Morphous CP250W Specifications

General

Brand	Yamaha
Model	Morphous CP250W
Category	Scooter
Language	English

Summary

Safety Information and Riding Guidelines

Safe Riding Practices

Essential advice for safe operation, including pre-ride checks, visibility, and hazard avoidance.

Protective Apparel and Loading Guidelines

Guidelines on essential protective gear and warnings for vehicle modifications, loading, and accessories.

Location of Important Labels

Identifies and explains the location and meaning of critical safety and information labels on the vehicle.

Instrument and Control Functions

Main Switch, Locks, and Indicators

Multi-function Display and Handlebar Controls

Brake System Operation

Pre-Operation Checks

Pre-Operation Checklist

A comprehensive list of checks to perform before each ride to ensure vehicle safety and readiness.

Operation and Important Riding Points

Starting the Engine and Riding Basics

Step-by-step instructions for starting the engine and beginning to ride safely.

Speed Control and Braking

Guidance on acceleration, deceleration, braking, and engine break-in procedures.

Parking Procedures

Periodic Maintenance and Minor Repair

Maintenance Schedules and Tool Kit

Fluid and Filter Service

Brake System, Tires, and Wheels Maintenance

Maintenance for tires, wheels, and the brake system, including fluid and pad checks.

Battery, Fuses, and Lighting System

Troubleshooting and Engine Overheating

Scooter Care and Storage