PERIODIC MAINTENANCE AND MINOR REPAIR
releasing the “OIL CHANGE” button,
otherwise repeat the procedure.
EAU20061
Final transmission oil
The final transmission case must be
checked for oil leakage before each
ride.
If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1.
Start the engine, warm up the final
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2.
Place the scooter on the center-
stand.
3. Place an oil pan under the final
transmission case to collect the
used oil.
4.
Remove the oil filler cap and drain
bolt to drain the oil from the final
transmission case.
1.
Final transmission oil filler cap
2.
Final transmission oil drain bolt
5. Install the final transmission oil
drain bolt, and then tighten it to the
specified torque.
Tightening torque:
Final transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
6. Add the specified amount of the
recommended final transmission
oil,
and then install and tighten the
oil filler cap.
6
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.25 L (0.26 US qt) (0.22 Imp.qt)
6-19
To Next Page
Loading...
Need help?
General