Yealink SIP-T30P Administrator's Guide

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
36
Menu > Advanced (default password: admin) > Network > LLDP > LLDP Status
Black-and-white Screen Phones:
Menu > Settings > Advanced Settings (default password: admin) > Network > LLDP > LLDP Status
Parameter
static.network.lldp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) that how often the phone sends the LLDP request.
Note: It works only if “static.network.lldp.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 3600
Default
60
Web UI
Network > Advanced > LLDP > Packet Interval (1~3600s)
Phone UI
Color Screen Phones:
Menu > Advanced (default password: admin) > Network > LLDP > Packet Interval
Black-and-white Screen Phones:
Menu > Settings > Advanced Settings (default password: admin) > Network > LLDP > Packet Interval
[1]
If you change this parameter, the phone will reboot to make the change take effect.
CDP Configuration
CDP (Cisco Discovery Protocol) allows the phones to receive and/or transmit device-related information from/to dir-
ectly connected devices on the local network.
When CDP feature is enabled on the phones, the phones periodically advertise their own information to the directly
connected CDP-enabled switch. The phones can also receive CDP packets from the connected switch and obtain
their VLAN IDs.
The following table lists the parameters you can use to configure CDP.
Parameter
static.network.cdp.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the CDP feature.
Permitted
Values
0-Disabled
1-Enabled, the phone attempts to determine its VLAN ID through CDP.
Default
1
Web UI
Network > Advanced > CDP > Active
Phone UI
Color Screen Phones:
Menu > Advanced (default password: admin) > Network > CDP > CDP Status
Black-and-white Screen Phones:
Menu > Settings > Advanced Settings (default password: admin) > Network > CDP > CDP Status
Parameter
static.network.cdp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) that how often the phone sends the CDP request.
Note: It works only if “static.network.cdp.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 3600
Default
60

Yealink SIP-T30P Specifications

General

Brand	Yealink
Model	SIP-T30P
Category	IP Phone
Language	English