To Next Page

To Previous Page

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones

For T48G phones: T48G

For T48S phones: T48S

For T46U phones: T46U

For T46G phones: T46G

For T46S phones: T46S

For T43U phones: T43U

For T42G phones: T42G

For T42S phones: T42S

For T42U phones: T42U

For T41P phones: T41P

For T41S phones: T41S

For T40P phones: T40P

For T40G phones: T40G

For T33G phones: T33G

For T33P phones: T33P

For T31G phones: T31G

For T31P phones: T31P

For T31 phones: T31

For T30P phones: T30P

For T30 phones: T30

For T29G phones: T29G

For T27G phones: T27G

For T23P phones: T23P

For T23G phones: T23G

For T21(P) E2 phones: T21P_E2

For T19(P) E2 phones: T19P_E2

For CP920 phones: CP920

Static Provision Configuration

To use the static provision method, you need to obtain the provisioning server address first when configuring a pro-

visioning server.

The provisioning server address can be IP address, domain name or URL. If a user name and password are spe-

cified as part of the provisioning server address, for example, http://user:pwd@server/dir, they will be used only if

the server supports them.

Note: A URL should contain forward slashes instead of backslashes and should not contain spaces. Escape characters are

not supported.

If a user name and password are not specified as part of the provisioning server address, the User Name and Pass-

word of the provisioning server configured on the phone will be used.

The following table lists the parameters you can use to configure static provision.

Yealink SIP-T30P Administrator's Guide

Other manuals for Yealink SIP-T30P