Yealink SIP-T46G User Manual

User Guide for the SIP-T46G IP Phone
148
to the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different from
introduced above. Contact your system administrator for more information.
Call Park
You can use call park feature to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You can park
an active call by pressing the Park soft key or call park key (if configured) on the phone. If the
call is parked successfully, there is a voice prompt confirming that the call was parked. You can
retrieve the parked call by pressing the Retrieve soft key or the retrieve key (if configured). If the
parked call is not retrieved within a period of time defined by the system, the phone performing call
park will receive the call back.
Note
The IP phone supports call park feature under the following modes:
 FAC mode: park the call to the local extension or a desired extension through dialing the
park code, and retrieve the parked call from the local extension or desired extension
through dialing the park retrieve code.
 Transfer mode: park the call to shared parking lot through performing a blind transfer to
a call park number (call park code), and retrieve the parked call from the shared parking lot
through dialing the park retrieve code.
You may need to configure the call park code and park retrieve code before using call park
feature. You can also configure a call park key and retrieve key. For more information, refer to
DSS Keys on page 89.
Note
FAC Mode
To configure call park feature in FAC mode via web user interface:
1. Click on Features->Call Pickup.
2. Select FAC from the pull-down list of Call Park Mode.
3. Select Enabled from the pull-down list of Call Park.
If Enabled is selected, the Park soft key will display on the LCD screen during a call, and the
Retrieve soft key will display on the dialing screen.
Call park is not available on all servers. Contact your system administrator for more information.
The call park code and park retrieve code are predefined on the system server. Contact your
system administrator for more information.

Yealink SIP-T46G Specifications

General

Backlight	Yes
Power requirements	100-240V, DC 5V
Touchscreen	-
Display diagonal	4.3 \
Display resolution	480 x 272 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
Voice codecs	G.711, G.722, G.723, G.726, G.729A, G.729B
Bluetooth	No
RJ-9 ports quantity	2
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports	1
Storage temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	185 mm
Width	244 mm
Height	213 mm