Yealink VC800 User Manual

User Guide for the VC800 Video Conferencing System
26
4. Lock the VC800 codec to the L-bracket with the M3×8 screws.
Installing Batteries for the Remote Control
Do the following:
1. Open the battery cover on the back of the remote control.
2. Insert the batteries with correct polarity.
3. Replace the battery cover.
Remote Control Battery Safety Information
 Never make wrong polarity connection when charging and discharging battery packs.
 Avoid crushing, puncturing, or putting a high degree of pressure on any battery, as this can
cause an internal short-circuit, resulting in overheating.
 Remove the batteries if they are not in use for long period of time. Battery leakage and
corrosion can damage the remote control, dispose batteries safely.
 Do not dispose used batteries in domestic waste. Dispose batteries at special collection
points or return to stores if applies.
 Do not dispose batteries in a fire.
Powering the System On
To power on the system:
1. Locate the DC48V port on the VC800 codec, and connect it to the electrical power outlet

Yealink VC800 Specifications

General

Brand	Yealink
Model	VC800
Category	Conference System
Language	English