Using the CPW90 Wireless Expansion Mic
173
To charge the CPW90:
1. Put the CPW90 on the charger cradle.
2. Connect the micro USB port on the charger cradle to the USB port on the CP960 using a
0.3m USB cable.
During charging, the battery LED indicator on the CPW90 illuminates solid red. When the
battery capacity reaches 100%, the battery LED indicator on the CPW90 will illuminate solid
green.
Note
Turning the CPW90 On or Off
After the CPW90 starts, it registers with the CP960 conference phone automatically. You can
turn off CPW90 if it is not in use for a long period of time.
To turn on the CPW90:
1. Do one of the following:
- Put the CPW90 on a charger cradle, the CPW90 will turn on automatically.
- Long tap the mute button on the CPW90 for 3 seconds.
To turn off the CPW90:
1. Long tap the mute button on the CPW90, until the battery indicator LED on the CPW90
illuminates solid red for 3 seconds and then goes out.
Registering CPW90 to the CP960 Conference Phone
To ensure good voice quality, CPW90 Wireless Expansion Mic can be connected to the CP960
conference phone to act as the audio input device.
If the CPW90 is not registered with the CP960 conference phone automatically, you should
register the CPW90 to the CP960 conference phone manually.
To register the CPW90 to the CP960 conference phone:
1. Do the following on the CP960 conference phone:
Tap ->Wireless Microphone.
If it is the first time you use the CPW90, you need to fully charge the CPW90 for normal use.
To Next Page
Loading...
Need help?
General
