Zapi ACE3 User Manual

AFFZP0BB – ACE3 – User Manual Page – 45/139
7.2.2 SET OPTIONS
SET OPTIONS
Parameter Allowable range Description
HM DISPLAY OPT.
(T, TM, P, CO)
0 ÷ 6 This parameter decides the configuration for the hour meter
shown on a display (i.e. MDI). The possible settings are the
same of HM CUSTOM 1 OPT. parameter.
HM CUSTOM 1 OPT.
(T, TM, P, CO)
0 ÷ 6 This parameter decides the configuration for the hour meter
number 1 accessible to the customer.
The possible settings are:
0: The hour meter counts since the controller is on.
1: The hour meter counts when the three-phase power
bridge is active
2: The hour meter counts when the DC motor power
bridge is active
3: The hour meter counts when one of the valve outputs
is active
4: The hour meter counts when the three-phase power
bridge is active or the DC motor power bridge is active
5: The hour meter counts when the DC motor power
bridge is active or one of the valve outputs is active
6: The hour meter counts when the three-phase power
bridge is active or the DC motor power bridge is active or
one of the valve outputs is active
Note: options 2, 4, 5 and 6 are not effective on ACE3
HM CUSTOM 2 OPT.
(T, TM, P, CO)
0 ÷ 6
This parameter decides the configuration for the hour meter
number 2 accessible to the customer. The possible settings
are the same of HM CUSTOM 1 OPT. parameter.
TILL/SEAT SWITCH
(T, TM, P)
HANDLE ÷ SEAT This option handles the input A6. This input opens when the
operator leaves the truck. It is connected to a key voltage
when the operator is present.
HANDLE = input A6 is managed as tiller input (no delay
when released).
DEADMAN = input A6 is managed as dead-man input
(no delay when released).
SEAT = input A6 is managed as seat input (with a delay
when released and the de-bouncing function).
EB ON TILLER BRK
(T)
OFF, ON This option defines how the electromechanical brake is
managed depending on the status of tiller/seat input:
ON = the electromechanical brake is engaged as soon
as the tiller input goes into OFF state. The deceleration
ramp defined by “tiller braking” parameter has no effect.
OFF = when the tiller input goes into OFF state, the “tiller
braking” ramp is applied before engaging the
electromechanical brake.

Zapi ACE3 Specifications

General

Brand	Zapi
Model	ACE3
Category	Inverter
Language	English