CJK Decode Control I - 3
CJK Output Method to Windows Host
Parameter # 972
For a national standard encoded CJK bar code, select one of the following options for CJK output to a
Windows host:
•
Universal CJK Output - This is the default universal CJK output method for US English IME or
Chinese/Japanese/Korean ASCII IME on a Windows host. This method converts CJK characters to
Unicode and emulates the characters when transmitting to the host. Use the Unicode Output Control
parameter to control Unicode output.
•
Other options for CJK output - With the following methods, the scanner sends the CJK character
hexadecimal internal code (Nei Ma) value to host, or converts the CJK character to Unicode and sends
the hexadecimal Unicode value to host. When using these methods, the Windows host must select the
corresponding IME to accept the CJK character. See Unicode/CJK Decode Setup with Windows Host on
page I-4.
• Simplified Chinese GBK Code Output
• Traditional Chinese Big5 Code Output (Windows 7)
NOTE To support universal CJK output, set up the registry table for the Windows host. See Unicode/CJK Decode
Setup with Windows Host on page I-4.
The Unicode emulate output method depends on the host system (Windows XP or Windows 7).
The CS4070 does not support Windows XP.
*Universal CJK Output
(0)
Chinese (Simplified) GBK Output
(1)
Chinese (Traditional) Big5 Output (Windows 7)
(19)
To Next Page
Loading...
Need help?
General
