Zebra CS4070 User Manual

3 - 56 CS4070 Scanner Product Reference Guide
Decode Session Timeout
Parameter # 136
SSI # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 5.0 seconds. The default timeout is 5.0 seconds.
To set a Decode Session Timeout, scan the following bar code. Next, scan two numeric bar codes from
Appendix F, Numeric Bar Codes that correspond to the desired on time. Enter a leading zero for single digit
numbers. For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan
the 0 and 5 bar codes. To correct an error or change the selection, scan Cancel on page F-3
.
Timeout Between Decodes, Same Symbol
Parameter # 137
SSI # 89h
Use this option in Continuous Bar Code Read mode to prevent the beeper from continuously beeping when a
symbol is left in the scanner’s field of view. The bar code must be out of the field of view for the timeout period
before the scanner reads the same consecutive symbol. It is programmable in 0.1 second increments from 0.0
to 5.0 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric
bar codes from Appendix F, Numeric Bar Codes that correspond to the desired interval, in 0.1 second
increments.
Decode Session Timeout
Timeout Between Decodes, Same Symbol

Zebra CS4070 Specifications

General

Brand	Zebra
Model	CS4070
Category	Barcode Reader
Language	English