User Preferences 3 - 47
Automatic Day/Night Mode
Parameter # 1393
SSI # F8h 05h 71h
Scan Enable Automatic Day/Night Mode to mute the beeper for all actions defined in Table 2-2 on page 2-7
from the Automatic Day/Night Start Time to the Automatic Day/Night Mode Stop Time OR based on the
Automatic Day/Night Mode Shift Profiles setting. This also enables the Decode Pager Motor (CS4070HC only)
during this time period.
NOTE There are two ways to temporarily disable Night Mode (Night Mode start/stop times remain intact):
• Scan *Do Not Mute Beeper (0) on page 3-38 or
• Hold the scan (+) button for greater than 10 seconds.
Night Mode is re-enabled (i.e., the beeper is muted) on pressing the scan (+) button for greater than 10
seconds or on the next Automatic Day/Night Mode start time.
CAUTION If this feature is enabled, the scanner sounds an error beep if the scanner Real Time Clock (RTC) is
not synchronized with the PC RTC. In this case, the Automatic Day/Night Mode start and stop times
may not trigger at the correct times. Use the RTCSync.exe utility on http://www.zebra.com/support to
synchronize the scanner and PC RTC from a factory defaults state or after removing and re-installing
the battery.
Enable Automatic Day/Night Mode
(1)
*Disable Automatic Day/Night Mode
(0)
To Next Page
Loading...
Need help?
General
