3 - 8 CS4070 Scanner Product Reference Guide
Bluetooth Options
Bluetooth Friendly Name
You can set a meaningful name for the scanner that appears in the application during device discovery. The
default name is the scanner name followed by its serial number, e.g.,
CS4070: 123456789ABCDEF. Scanning
Reset Factory Defaults reverts the scanner to this name; use 123Scan2 set defaults to maintain the
user-programmed name through a Set Defaults operation.
To set a new Bluetooth Friendly Name, scan the following bar code, then scan up to 23 characters from
Appendix G, Alphanumeric Bar Codes. If the name contains less than 23 characters, scan End of Message on
page G-7 after entering the name.
NOTE If your application allows you to set a device name, this takes precedence over the Bluetooth Friendly
Name.
Bluetooth Friendly Name
To Next Page
Loading...
Need help?
General
