55
Replacing Parts
Replacing the Motor
8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
Replacing the Motor
You must remove the bottom case before performing this procedure.
Removal
The motor is located on the right side of the printer under the media compartment.
1. Pull the motor’s wire bundle away from its connector on the Main Logic circuit board.
2. Disconnect the motor’s ground wire from the Main Logic circuit board. For printers with
the cutter option, disconnect this ground wire from the ‘Y’ connector joining the cutter
and motor ground wires to connect to the Main Logic circuit board.
3. Use a M3 nut driver to remove the nuts holding the motor, two washers and ground clip to
the inner chassis. Carefully pull the motor away from the chassis and out of the printer.
Caution • Prepare your work area by protecting against static discharge. Your work area
must be static-safe and include a properly grounded conductive cushioned mat to hold the
printer and a conductive wrist strap for yourself.
To Next Page
Loading...
Need help?
General
