61
Replacing Parts
Replacing the Dispenser (Peel Option) Bezel
8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
Replacing the Dispenser (Peel Option) Bezel
You must remove the platen roller and bottom case before performing this procedure.
Removal
The dispenser is located on the front of the printer below the media exit.
1. With the printer open and upright, open the dispenser door.
2. Remove the peel-bar. Lift the left side away from bearing; then pull the right side away
from the printer.
3. Close the dispenser door.
4. Turn the printer upside down.
5. Carefully pull the dispenser’s connector off of the Main Logic circuit board.
6. Use a #1 Phillips screwdriver to loosen and remove the screws on the left and right sides.
7. Lift the dispenser (peel option) away from the printer.
Caution • Prepare your work area by protecting against static discharge. Your work area
must be static-safe and include a properly grounded conductive cushioned mat to hold the
printer and a conductive wrist strap for yourself.
To Next Page
Loading...
Need help?
General
