Replacing Parts
Replacing the Dispenser (Peel Option) Bezel
62
980618-001 A Thermal Transfer G-Series
TM
Service Manual 8/27/08
Installation
1. With the dispenser out of the printer, make sure to close the dispenser door.
2. With the printer upside down, align the dispenser so that the mounting holes face the rear
of the printer and the white roller faces to the top of the printer.
3. Place the dispenser against the printer.
4. Route the dispenser’s wire bundle above the tab and to the right of the frame’s wall.
5. Replace the screws and use a #1 Phillips screwdriver to tighten them.
6. Plug the wire bundle into its connector on the Main Logic circuit board.
7. Turn the printer right side up and open the dispenser door.
8. Align the peel bar so that the flat side faces up towards the top of the printer.
9. Install the peel bar. Insert the right side into the printer and rotate the left side down so that
it seats securely.
Replace the bottom case. Reload media. Plug in power, turn on the printer and print a status
report to ensure proper function.
To Next Page
Loading...
Need help?
General
