Zebra S4M User Manual

About This Document
Who Should Use This Document
10
13290L-004 Rev. A S4M User Guide 6/15/09
Who Should Use This Document
This User Guide is intended for use by any person who needs to operate or troubleshoot
problems with the printer.
How This Document Is Organized
The User Guide is set up as follows:
Section Description
Introduction on page 15 This section shows the operational controls and
location of major components used when loading
media and ribbon. Other features of the printer are
discussed.
Printer Setup on page 23 This section provides the tasks that you must
complete and the issues that you must consider
before you load and configure your printer.
Operations on page 37 This section provides the procedures for loading
and calibrating the printer.
Configuration on page 63 This section discusses printer configuration
settings and instructs you how to view or change
printer parameters through the control panel.
Routine Maintenance on page 87 This section provides routine cleaning and
maintenance procedures.
Troubleshooting on page 99 This section provides information about errors that
you might need to troubleshoot. Assorted
diagnostic tests are included.
Specifications on page 125 This section provides the features of and
specifications for the printer.

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g