Zebra S4M User Manual

Printer Setup
Before You Begin
24
13290L-004 Rev. A S4M User Guide 6/15/09
Before You Begin
Review this checklist, and resolve any issues before you set up or use your printer.
 Unpack and Inspect the Printer Have you unpacked the printer and inspected it for
damage? If you have not, see Unpack and Inspect the Printer on page 25.
 Select a Site Have you selected an appropriate location for the printer? If you have not,
see Select a Site for the Printer on page 26.
 Connect to a Data Source Have you determined how the printer will connect to a
data source (usually a computer)? For more information, see Select a Data
Communication Interface on page 27.
 Attach a Power Cord Do you have the correct power cord for your printer? If you are
unsure, see Power Cord Specifications on page 31. To attach the power cord and connect
the printer to a power source, see Connect the Printer to a Power Source on page 30.
 Select Media Do you have the correct media for your application? If you are unsure,
see Types of Media on page 32.
 Select Ribbon Do you need to use ribbon, and is the appropriate ribbon available, if
needed? If you are unsure, see Ribbon Overview on page 34.

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g