Zebra S4M User Manual

71
Configuration
Select a Display Language
6/15/09 S4M User Guide 13290L-004 Rev. A
Select a Display Language
The LANGUAGE parameter is included in password level 3 and level 4 so you can easily reach
the parameter to select a familiar language if you cannot read the one being displayed.
To change the language displayed, complete these steps:
1. On the control panel, press MENU.
The printer enters Setup mode.
2. Press the left arrow.
If a password is set for level 3 or 4, the printer displays
ADVANCED SETUP with the
level number, and the
ENTER button is enabled. If no passwords are set for level 3 or 4,
the printer displays
LANGUAGE.
3. What does the printer display?
4. Use the up and down arrows until you reach the language of your choice.
5. Press MENU.
The printer prompts you to accept changes.
6. If necessary, press the up or down arrow to select YES.
7. Press ENTER to accept the language that you selected.
If the printer displays... Then...
ADVANCED SETUP 1
*
ADVANCED SETUP 2
*
ADVANCED SETUP 3
*
ADVANCED SETUP 4
*
a. Press ENTER.
The printer displays
PASSWORD 0000
*
.
b. Use the left and right arrows to enter the password
for level 3 or 4.
c. Press ENTER.
The printer displays
LANGUAGE
*
.
LANGUAGE
*
Continue with the next step.
* Displays in the last language selected.

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g