Zebra S4M User Manual

113
Troubleshooting
Miscellaneous Printer Problems
6/15/09 S4M User Guide 13290L-004 Rev. A
Non-continuous
labels are being
treated as continuous
labels.
The printer was not calibrated
for the media being used.
Perform the calibration procedure in Calibrate
Media and Ribbon Sensors on page 85.
All lights are on, but
nothing displays on
the LCD, and the
printer locks up.
Internal electronic or firmware
failure.
Call a service technician.
The printer locks up
while running the
Power-On Self Test.
Main logic board failure. Call a service technician.
Table 23 • Miscellaneous Printer Problems (Continued)
Problem Possible Cause Recommended Solution

Zebra S4M Specifications

General

Flash memory	4 MB
Internal memory	8 MB
Dimensions (WxDxH)	272 x 477 x 295 mm
Media types supported	continuous, die-cut, tag, black mark
Media thickness	0.076 - 0.15 mm
RS-232 ports	1
Standard interfaces	USB 2.0
Storage temperature (T-T)	5 - 40 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	12400 g