ABB 650 series Engineering Manual

Section 1 Introduction
1.1 This manual
The engineering manual contains instructions on how to engineer the IEDs using the
various tools available within the PCM600 software. The manual provides
instructions on how to set up a PCM600 project and insert IEDs to the project
structure. The manual also recommends a sequence for the engineering of protection
and control functions, LHMI functions as well as communication engineering for IEC
60870-5-103, IEC 61850 and DNP 3.0.
1.2 Intended audience
This manual addresses system and project engineers involved in the engineering
process of a project, and installation and commissioning personnel, who use technical
data during engineering, installation and commissioning, and in normal service.
The system engineer must have a thorough knowledge of protection and/or control
systems, protection and/or control equipment, protection and/or control functions and
the configured functional logics in the IEDs. The installation and commissioning
personnel must have a basic knowledge of handling electronic equipment.
1MRK 511 284-UEN A Section 1
Introduction
650 series 5
Engineering manual

ABB 650 series Specifications

General

Brand	ABB
Model	650 series
Category	Controller
Language	English