Actual signals and parameters 261
RESET EFB protocol is performing a hardware reset. 6
LISTEN ONLY EFB protocol is in listen-only mode. 7
5310 EFB PAR 10 Selects an actual value to be mapped to Modbus register
40005.
0
0…65535 Parameter index 1 = 1
5311 EFB PAR 11 Selects an actual value to be mapped to Modbus register
40006.
0
0…65535 Parameter index 1 = 1
5312 EFB PAR 12 Selects an actual value to be mapped to Modbus register
40007.
0
0…65535 Parameter index 1 = 1
5313 EFB PAR 13 Selects an actual value to be mapped to Modbus register
40008.
0
0…65535 Parameter index 1 = 1
5314 EFB PAR 14 Selects an actual value to be mapped to Modbus register
40009.
0
0…65535 Parameter index 1 = 1
5315 EFB PAR 15 Selects an actual value to be mapped to Modbus register
40010.
0
0…65535 Parameter index 1 = 1
5316 EFB PAR 16 Selects an actual value to be mapped to Modbus register
40011.
0
0…65535 Parameter index 1 = 1
5317 EFB PAR 17 Selects an actual value to be mapped to Modbus register
40012.
0
0…65535 Parameter index 1 = 1
5318 EFB PAR 18 For Modbus: Sets an additional delay before the drive
begins transmitting response to the master request.
0
0…65535 Delay in milliseconds 1 = 1
5319 EFB PAR 19 ABB drives profile (ABB DRV LIM or ABB DRV FULL)
Control word. Read only copy of the Fieldbus Control word.
0000 hex
0000…FFFF
hex
Control word
5320 EFB PAR 20 ABB drives profile (ABB DRV LIM or ABB DRV FULL)
Status word. Read only copy of the Fieldbus Status word.
0000 hex
0000…FFFF
hex
Status word
5321 MDB DATA IN
1
Modbus register 40013 (read-only).
Supported only by STD MODBUS.
0
0...9999 Parameter index 1 = 1
5322 MDB DATA IN
2
Modbus register 40014 (read-only).
Supported only by STD MODBUS.
0
0...9999 Parameter index 1 = 1
All parameters
No. Name/Value Description Def/FbEq
To Next Page
Loading...
Need help?
General
