AO2000 CONTINUOUS GAS ANALYZERS | OI/AO2000-EN REV. B 165
Configuring a component
Menu path
MENU → Configure → Component-specific → Active Component
After selecting the component the menu "Configure component" is called up
with the softkey COMP. CONFIG.
Display
All the components of a detector are listed in the menu ("component list").
The following information is shown for each component:
Type S
System component = a component configured at the factory
S A
Active, i.e. system component currently being measured
S K
System component used for calibration
B
User component = a component configured by the user
B A
Active, i.e. user component currently being measured
B K
User component used for calibration
Name above
Name of the component in the measured value display, e.g. total formula
below
Full name of the component
Unit
The physical unit used for the measured value display
If not all four possible components of the detector are configured, the entry
"Free" appears at a point in the list.
To Next Page
Loading...
Need help?
General
