4 Repair
4.5.5. Unloading the balancing device using hydraulic press tool.
3213HAC022033-001 Revision: K
© Copyright 2004-2011 ABB. All rights reserved.
Required equipment
Using the correct press device
The different designs of the balancing device require different versions of the press device,
included in the complete press tool. The table below specifies which press device to use to
which balancing device.
The article number of the balancing device may be found on a label at the rear of the balancing
device.
Equipment, etc. Art. no. Note
Press tool, balancing device 3HAC020902-001 Includes
• press device 3HAC15767-2
• press device 3HAC18100-1
Choose the correct device, depending
on model of balancing device.
Hydraulic cylinder 3HAC11731-1 To be used with the press tool.
Hydraulic pump, 80 MPa 3HAC13086-1 To be used with the hydraulic cylinder.
Standard toolkit - Content is defined in section Standard
toolkit on page 427.
Balancing device Press device
xx0300000605
Art. no: 3HAC14675-2
xx0700000423
Art. no: 3HAC023018-001
xx0300000600
Art. no: 3HAC15767-2 (for balancing
device 3HAC14675-1)
xx0300000599
Art. no: 3HAC18100-1 (for balancing
device 3HAC023018-001)
Continued
Continues on next page
To Next Page
Loading...
Need help?
General
