2 Installation and commissioning
2.5.11. Installation of cooling fan for motors, axes 1-3 (option)
3HAC022033-001 Revision: K104
© Copyright 2004-2011 ABB. All rights reserved.
2.5.11. Installation of cooling fan for motors, axes 1-3 (option)
General
A cooling fan can be installed on the motors of axes 1, 2 and 3.
Cooling fans for axes 1 and 2 can not be combined!
The cabling for the fans is available in different design:
• complete cabling, including connections for both cooling fans and position switches,
at axes 1, 2 and 3. Installation of this complete cabling is detailed in section
Installation of cable harness for position switches and fans on page 129.
• separate cabling for axis 1 or 2, including only connections for the cooling fans on
axes 1 or 2. Installation of this cabling is detailed in section Installation, separate fan
cabling axis 1 or 2 on page 109.
If both cooling fans and position switches are installed on the robot, the complete cabling
must be used! It can not be combined with the separate cabling.
Location of cooling fans
The fans are installed on the motors, axes 1-3, as shown in the figure below.
xx0500002157
A Cooling fan, axis 1
B Cooling fan, axis 2
C Cooling fan, axis 3
D Rear cover plate
Continues on next page
To Next Page
Loading...
Need help?
General
