Softstarters Type PSE18...PSE370 Installation and commissioning manual 1SFC132057M0201 73 Chapter 7
7.5.12.4 Type of Operation for Reset of Fieldbus Fault
Select what operation shall be asserted if a eldbus communication fault occurs.
Manual or automatic options are available. HAnd is the default value for reset of
Fieldbus Fault:
• If HAnd is selected - The motor will stop and manual reset is required.
• If Auto is selected - The motor will stop and automatic reset is performed.
This parameter is accessible only if trIP is previously selected for the parameter
eldbus Operation When Fault.
Display Default
value
Setting
range
Description
HAnd HAnd/Auto Type of operation for reset of Field-
bus Fault.
1
1. HAnd = Manual reset: _When tripping will stop the motor, a manual reset is
required before restart can be done.
Auto = Automatic reset: _When tripping will stop the motor, an automatic reset is
performed before the unit is ready for restart.
7.6 Reset of tripping events
In case of tripping event the PSE Softstarter can be reset via hardwire, keypad,
external keypad, or Fieldbus.
If the setting HAnd is chosen as an action in case of an tripping event for a pa-
rameter with this option, manual resetting of the softstarter is required.
If the setting Auto is chosen as an action in case of an tripping event for a param-
eter with this option, resetting of the softstarter will be performed automatically.
Figure 7.31: Type of operation for reset of
Fieldbus fault parameter displayed
Ready Run
Exit
Select
Reset
Protection
Fault
Figure 7.32: Reset of tripping events
To Next Page
Loading...
Need help?
General
