ABB PSE 18 User Manual

Softstarters Type PSE18...PSE370 Installation and commissioning manual 1SFC132057M0201 93 Chapter 10
Status Possible cause Solution
Transfer of parameters failed
Only showing on external keypad. Can
occur for transfer both from the PSE and
to the PSE. Same failure for F1, F2, F3, F4
and F6.
Ready Run Protection
Fault
Fault in software. • Try again.
• If the same failure remains, contact
your local ABB Sales Ofce.
Transfer of parameters failed
Only showing on external keypad. Can
occur for transfer to the PSE.
Ready Run Protection
Fault
No parameters stored in the PSEEK. • Load the parameters that you want to
transfer from selected PSE.
• If the same failure remains, contact
your local ABB Sales Ofce.
All parameters was not transferred
Only showing on external keypad. Can
occur for transfer both from the PSE and
to the PSE.
Ready Run Protection
Fault
Fault in software. • Try again.
• If the same failure remains, contact
your local ABB Sales Ofce.
Transfer of parameters failed
Only showing on external keypad. Can
occur for transfer to the PSE.
Ready Run Protection
Fault
Not possible to transfer parameters to PSE
when it is in TOR.
• Return the PSE to idle state and try
again
• If the same failure remains, contact
your local ABB Sales Ofce.
10.8 Failure indications

ABB PSE 18 Specifications

General

Brand	ABB
Model	PSE 18
Category	Controller
Language	English