KNX control elements and application parameters
Control element: "Value slider"
Product manual 2CKA00xx73xxxxx
159
10.12.5 Display value in control element
Options: Deactivated
Activated
The parameter is used to specify whether the value is displayed in the control element.
– Deactivated: No display. No additional parameters available.
– Activated: The following supplementary parameters are displayed:
Status value is controlled by a separate object:
Options: Deactivated
Activated
An additional 1-bit communication object "Status value" is enabled via the parameter. If an
actuator has a separate object to feed back the status, it can be linked with a separate
feedback object.
Unit:
Options: <Text>
The parameter is used to enter the unit or the unit sign with which the value is displayed in
the control element.
The length is limited to 20 characters.
Decimal places:
Options: Setting option from 0 - 2
The parameter is used to specify the number of decimal places of the displayed value.
The number is limited to 2 places.
10.12.6 Slider sends
Options: When releasing the slider
Cyclic
The parameter is used to specify whether the signal is sent "When releasing the slider" or
"Cyclic".
– When releasing the slider: No additional parameters available.
– Cyclic: The following supplementary parameter is available:
Telegram is repeated every [sec.]:
Options: Setting option from 0.25 - 1.25 seconds
The parameter is used to specify the space of time between two value telegrams.
To Next Page
Loading...
Need help?
General
