KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA00xx73xxxxx
240
10.24.82 Temperature reading — Weighting of external measurement 2 (0 to 100%)
Options: Setting option between 0 - 100
Specifying the weighting of the external measurement 2 from 0 to 100%. The setting together
with the weighting of the external measurement (0 - 100%) must result in 100%.
Note
This parameter is only available when the "Inputs of weighted temperature
reading" parameter is set on "2x external measurement" or "Internal and 2x
external measurement".
10.24.83 Temperature reading — Cyclic sending of the actual temperature (min)
Options: Setting option between 5 - 240
The current actual temperature used by the device can be cyclically transmitted to the bus.
10.24.84 Temperature reading — Difference of value for sending the actual temperature (x 0.1°C)
Options: Setting option between 1 - 100
If the change in temperature exceeds the parameterised difference between the measured
actual temperature and the previous actual temperature that was sent, the changed value will
be transmitted.
Note
This parameter is only available when the "Inputs of temperature reading"
parameter is set on "Internal measurement" or "Weighted measurement".
To Next Page
Loading...
Need help?
General
