34 Chapter 2
System Security
The System Security screen contains parameters that help safeguard and protect your computer from
unauthorized use.
The following table describes the parameters in this screen. Settings in
boldface
are the default and
suggested parameter settings.
Setting a Password
Follow these steps:
1.
Use the cursor up/down keys to highlight a Password parameter (Setup, Power-on or Hard Disk) and
press the
cursor left/right
key. The password box appears:
2.
Type a password. The password may consist of up to eight characters (A-Z, a-z, 0-9).
IMPORTANT:
Be very careful when typing your password because the characters do not appear on the
screen.
3.
Press
Enter
. Retype the password to verify your first entry and press
Enter
.
4.
After setting the password, the computer automatically sets the chosen password parameter to Present.
Parameter Description Options
Setup Password When set, this password protects the computer and the BIOS
Utility from unauthorized entry. See the following section for
instructions on how to set a password.
None
or Present
Power-on Password When set, this password protects the computer from
unauthorized entry. See the following section for instructions
on how to set a password.
None
or Present
Hard Disk Password When set, this password protects the hard disk from
unauthorized access. See the following section for
instructions on how to set a password.
None
or Present
To Next Page
Loading...
Need help?
General