127
Chapter 3 Features and Functions
Factory Default Settings
3
Factory Default Settings
Output Configuration
Function
Frequency
Amplitude / Offset
Output Units
Output Termination
Autorange
Modulation (AM, FM, FSK)
Carrier Waveform
Modulating Waveform
AM Depth
FM Deviation
FSK “Hop” Frequency
FSK Rate
Modulation State
Sweep
Start / Stop Frequency
Sweep Time
Sweep Mode
Sweep State
Burst
Burst Frequency
Burst Count
Burst Period
Burst Starting Phase
Burst State
System-Related Operations
•
Power-Down Recall
Display Mode
Error Queue
Stored States, Stored Arbs
Output State
Triggering Operations
Trigger Source
Remote Interface Configuration
•
GPIB Address
•
Interface
•
Baud Rate
•
Parity
•
Handshake
Calibration
Calibration State
Factory Setting
Sine wave
1 kHz
100 mVpp / 0.000 Vdc
Vpp
50Ω
On
Factory Setting
1 kHz Sine wave
100 Hz Sine wave
100%
100 Hz
100 Hz
10 Hz
Off
Factory Setting
100 Hz / 1 kHz
1 Second
Linear
Off
Factory Setting
1 kHz
1 Cycle
10 ms
0°
Off
Factory Setting
•
Disabled
On
Errors are Cleared
No Change
Off
Factory Setting
Internal (Immediate)
Factory Setting
•
10
•
GPIB (IEEE-488)
•
57,600 Baud
•
None (8 data bits)
•
DTR / DSR
Factory Setting
Secured
For your convenience,
this table is duplicated
on the rear cover of this
manual and on the
Quick Reference Card.
Note:
The power-on
state will be different
if you have enabled
the power-down
recall mode.
See “Instrument State
Storage” on page 109.
Parameters marked with a bullet (
•
) are stored in non-volatile memory
.
To Next Page
Loading...
Need help?
General
