132
Chapter 4 Remote Interface Reference
SCPI Command Summary
4
Command Summary
(see page 153 for more information)
FUNCtion {SINusoid|SQUare|RAMP|PULSe|NOISe|DC|USER}
FUNCtion?
FREQuency {<frequency>|MINimum|MAXimum}
FREQuency? [MINimum|MAXimum]
VOLTage {<amplitude>|MINimum|MAXimum}
VOLTage? [MINimum|MAXimum]
VOLTage:OFFSet {<
offset>|MINimum|MAXimum}
VOLTage:OFFSet? [MINimum|MAXimum]
VOLTage
:HIGH {<
voltage>|MINimum|MAXimum}
:HIGH? [MINimum|MAXimum]
:LOW {<
voltage>|MINimum|MAXimum}
:LOW? [MINimum|MAXimum]
VOLTage:RANGe:AUTO {OFF|ON|ONCE}
VOLTage:RANGe:AUTO?
VOLTage:UNIT {VPP|VRMS|DBM}
VOLTage:UNIT?
FUNCtion:SQUare:DCYCle {<
percent>|MINimum|MAXimum}
FUNCtion:SQUare:DCYCle? [MINimum|MAXimum]
FUNCtion:RAMP:SYMMetry {<
percent>|MINimum|MAXimum}
FUNCtion:RAMP:SYMMetry? [MINimum|MAXimum]
OUTPut {OFF|ON}
OUTPut?
OUTPut:LOAD {<
ohms>|INFinity|MINimum|MAXimum}
OUTPut:LOAD? [MINimum|MAXimum]
OUTPut:POLarity {NORMal|INVerted}
OUTPut:POLarity?
OUTPut:SYNC {OFF|ON}
OUTPut:SYNC?
Output Configuration Commands
Parameters shown in bold are selected following a *RST (reset) command.
To Next Page
Loading...
Need help?
General
