To Next Page

To Previous Page

Changing The Default Setting 4

Agilent U1251B/U1252B User’s and Service Guide 97

Setting the DC Filter

This setting is used to filter AC signals in DC measuring

paths. The DC filter is set to “OFF” by default. To enable

this function, set this to “On”.

Figure 4-18 DC filter

Press

NOTE

• When DC filter is enabled, the measurement speed may decrease

during DC voltage measurement.

• During AC or Hz measurement (on primary or secondary display), DC

filter will be automatically disabled.

Agilent Technologies U1252B User Manual

Questions and Answers: