Agilent Technologies U1252B User Manual (English)

Questions and Answers:

J
James CollinsJul 30, 2025
What to do if the Agilent Technologies U1252B Multimeter battery life is very short after a full charge?
- C
  Courtney AlvarezJul 30, 2025
  If the battery life of your Agilent Technologies Multimeter is shorter than expected after a full charge, or if the battery won't charge after being stored for a long time: * Ensure the correct rechargeable battery is being used. * Try charging and discharging the battery for 2 or 3 cycles to help maintain its maximum capacity. Keep in mind that rechargeable batteries may degrade over time.
W
wsmithAug 3, 2025
What to do if my Agilent Technologies U1252B is not charging?
- R
  Rachel BrownAug 4, 2025
  If your Agilent Technologies Multimeter isn't indicating that it's charging: * First, check the 440 mA fuse. * Verify that the external adapter's output is DC 24 V and that it's fully plugged into the charging terminals. * Confirm that the line power voltage is within the range of 100V~240V AC 50 Hz/ 60 Hz.
P
peter98Aug 9, 2025
How to fix fail on remote control of Agilent Technologies U1252B?
- B
  brian37Aug 9, 2025
  To resolve remote control issues with your Agilent Technologies Multimeter: * Ensure the optical side of the cable is connected to the meter and the text side of the cover is facing up. * Check the baud rate, parity, Data bit, and Stop bit settings (the default is 9600, n, 8, 1). * Make sure the driver is installed for IR-USB.
G
Gabriella BryanAug 14, 2025
What to do if Agilent Technologies Multimeter fails on current measurement?
- P
  Pamela MiddletonAug 14, 2025
  If your Agilent Technologies Multimeter is failing during current measurements, check the fuse.
M
Melanie RamirezAug 18, 2025
Why is there no beeper tone on my Agilent Technologies Multimeter?
- R
  Robert JordanAug 19, 2025
  If you're not hearing a beeper tone from your Agilent Technologies Multimeter, check the setup mode to see if the beeper is turned off. If it is, select the desired driving frequency to turn it back on.
A
Alejandra White MDAug 25, 2025
How to fix no LCD display on Agilent Technologies U1252B?
- S
  Samantha RayAug 25, 2025
  If there is no LCD display after turning on your Agilent Technologies Multimeter, check the battery. Charge or replace it.

Agilent Technologies U1252B Specifications

General

Max Voltage Measurement	1000 V
Max Current Measurement	10 A
Resistance Measurement	Yes
Capacitance Measurement	Yes
Frequency Measurement	Yes
Temperature Measurement	Yes
Data Logging	Yes
Operating Temperature	0 °C to 50 °C
Safety Category	CAT III 1000 V, CAT IV 600 V
Diode Test	Yes
Continuity Test	Yes
DC Voltage Range	100.00 mV to 1000.0 V
AC Voltage Accuracy	0.5%
DC Current Range	100 µA to 10 A
AC Current Range	100 µA to 10 A
Resistance Range	100 Ω to 100 MΩ
Temperature Range	-40°C to 1000°C
Connectivity	USB
Weight	Approx. 500 g