Getting Started 1
U3402A User’s and Service Guide 5
Connecting Power to the Multimeter
Connect the power cord and press the power switch to turn on the multimeter.
The front panel display illuminates while the multimeter performs its
power- on self- test. (If the multimeter does not power- on, refer “Operating
Checklist” on page 76). During the power- on session, press to hold the
full display. Press any key to resume the power- on self- test.
The multimeter powers up in the DC voltage function with autoranging
enabled. If self- test is successful, the multimeter goes to normal operation.
If the self- test fails, either a full annunciator or a blank display is displayed
without entering the normal operation. If the unlikely event that self- test
repeatedly fails, contact your nearest Agilent Sales and Service Office.
The multimeter will operate at any line voltage between 90 VAC and 264 VAC when the line
voltage selector is set properly with frequency range 50 Hz or 60 Hz.
• Before turning on the multimeter, make sure the line voltage selector is set to the
correct position for the applied line voltage to the power line cord connector.
• Do not apply a line voltage that exceeds the specified range of the line cord
connector.
U3402-90001.book Page 5 Friday, July 24, 2009 4:04 PM
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
Need help?
General
