PowerFlex® 700S Drives - Phase I Control (Frame Sizes 9 & 10) 41
Applying Power to the Drive
The RUN LED, controller LEDs, and SynchLink LEDs are only operational when
the drive is energized. These LEDs are only visible when the drive door is open.
5. Apply AC power and control voltages to the drive. Examine the Power (PWR)
LED.
!
ATTENTION: The RUN LED and the controller LEDs are only operational when the drive is energized.
Servicing energized equipment can be hazardous. Severe injury or death can result from electrical shock, burn
or unintended actuation of controlled equipment. Follow Safety related practices of NFPA 70E, ELECTRICAL
SAFETY FOR EMPLOYEE WORKPLACES. DO NOT work alone on energized equipment!
➋
➊
➌
To Next Page
Loading...
Need help?
General
