AMX MIO-R4 Instruction Manual

Programming the Mio R-4
37
Mio Modero R-4 Remote
Page Commands (Cont.)
@PDR Set the popup location reset flag. If the flag is set, the popup will return to its default location on show instead of
its last drag location.
Syntax:
SEND_COMMAND <DEV>,"'@PDR-<popup page name>;<reset flag>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the
• popup is displayed On.
• reset flag = 1 = Enable reset flag
0 = Disable reset flag
Example:
SEND_COMMAND Device,"'@PDR-Popup1'"
Popup1 will return to its default location when turned On.
@PHE Set the hide effect for the specified popup page to the named hide effect.
Syntax:
SEND_COMMAND <DEV>,"'@PHE-<popup page name>;<hide effect name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
• hide effect name = Refers to the popup effect names being used.
Example:
SEND_COMMAND Panel,"'@PHE-Popup1;Slide Left'"
Sets the Popup1 hide effect name to 'Slide Left'.
@PHP Set the hide effect position. Only 1 coordinate is ever needed for an effect, however the command will specify
both. This command sets the location at which the effect will end at.
Syntax:
SEND_COMMAND <DEV>,"'@PHP-<popup page name>;<x coordinate>,<y coordinate>'"
Variable:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'@PHP-Popup1;75,0'"
Sets the Popup1 hide effect x-coordinate value to 75 and the y-coordinate value to 0.
@PHT Set the hide effect time for the specified popup page.
Syntax:
SEND_COMMAND <DEV>,"'@PHT-<popup page name>;<hide effect time>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
• hide effect time = Given in 1/10ths of a second.
Example:
SEND_COMMAND Device,"'@PHT-Popup1;50'"
Sets the Popup1 hide effect time to 5 seconds.
@PPA Close all popups on a specified page. If the page name is empty, the current page is used. This command works
in the same way as the 'Clear Page' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'@PPA-<page name>'"
Variable:
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'@PPA-Page1'"
Close all popups on Page1.

AMX MIO-R4 Specifications

General

Flash memory	32 MB
RAM capacity	64 MB
Certification	FCC, IC, CE, IEC 60950, Japan Approval
Maximum range	30 m
Frequency band	2.4 GHz
Languages support	ARA, CHI (SIMPL), DEU, ENG, ESP, FRE, GRE, HUN, ITA, JPN, KOR, POR, RUS, THA
Number of devices supported	2
Interface	IR Wireless
Input type	Press buttons
Hard buttons	Yes
Product color	Black
Buttons quantity	29
Remote control proper use	-
Display diagonal	2.4 \
Display resolution	240 x 320 pixels
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Package weight	25 g

Weight and Dimensions

Depth	19 mm
Width	51 mm
Height	240 mm
Weight	20 g