Autonics CX Series User Manual

Safety Considerations
vi © Copyright Reserved Autonics Co., Ltd.
Safety Considerations
 Following these safety considerations will ensure the safe and proper use of the product
and help prevent accidents, as well as minimizing possible hazards.
 Safety considerations are categorized as Warnings and Cautions, as defined below:
Warning
Failure to follow these instructions may result in serious
injury or death.
Caution
Failure to follow these instructions may result in personal
injury or product damage.
 Fail-safe device must be installed when using the unit with machinery that may cause
serious injury or substantial economic loss. (e.g. nuclear power control, medical equipment,
ships, vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster
prevention devices, etc.)
Failure to follow this instruction may result in fire, personal injury, or economic loss.
 Install on a device panel to use.
Failure to follow this instruction may result in electric shock or fire.
 Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in electric shock or fire.
 Check ‘Connections’ before wiring.
Failure to follow this instruction may result in fire.
 Do not disassemble or modify the unit.
Failure to follow this instruction may result in electric shock or fire.
 When connecting the power input and relay output, use AWG 20 (0.50mm
2
) cable or over,
and tighten the terminal screw with a tightening torque of 0.74 to 0.90N
.
m.
Failure to follow this instruction may result in fire or malfunction due to contact failure.
 Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
 Use the unit within the rated specifications.
Failure to follow this instruction may result in shortening the life cycle of the unit, or fire.
 Do not use the unit in the place where flammable/explosive/corrosive gas, humidity, direct
sunlight, radiant heat, vibration, impact, or salinity may be present.
Failure to follow this instruction may result in fire or explosion.
 Keep metal chip, dust, and wire residue from flowing into the unit.
Failure to follow this instruction may result in fire or product damage.
The specifications and dimensions of user manual are subject to change and some
models may be discontinued without notice.
Be sure to follow cautions written in the instruction manual, user manual and the
technical descriptions (catalog, homepage).

Autonics CX Series Specifications

General

Brand	Autonics
Model	CX Series
Category	Timer
Language	English