Service Commands
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 100
14. Service Commands
14.1 Introduction
From the operator panel you can perform service commands. To use
the Service Commands, access level 3 is required.
3 Password restricted. Accessible by persons trained and authorized to do
reconfiguration of site specific data and maintenance
according to the manufacturer’s published instruction.
4 Mechanical tool. Accessible by persons doing repair work and changing
firmware.
14.2 Service Menu
The Service Menu includes the following submenus:
Note that the Oil&Gas Commands apply only to oil&gas systems.
To Next Page
Loading...
Need help?
General
