Autronica BS-430 User Manual

Show Status
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 72
10.8 Show Status – Activated Outputs
This menu gives detailed information on activated outputs.
The example below describes how to view the current status of
activated outputs.
Step Actions to be taken Display Indication
1
To enter the Main Menu, press the Menu button
2
To select SHOW STATUS, press 1.
3
To select ACTIVATED OUTPUTS, press 6.
The 3 steps above will lead you to Show Status – Acitivated Outputs, where you can continue viewing
the status of the activated outputs (1-5), shown on the following page (step 4).
MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
SHOW STATUS
1 FIRE ALARMS
2 FIRE WARNINGS
3 FAULTS
4 DISABLEMENTS
5 DETECTION ZONES IN TEST
6 ACTIVATED OUTPUTS
7 ACTIVE SENSORS
8 OIL&GAS INHIBITED POINTS
19:23
SHOW STATUS
ACTIVATED OUTPUTS
1 DOOR CONTROL UNITS
2 LOW LOCATION LIGHT UNITS
3 STANDARD CONTROL UNITS
4 OTHER OUTPUTS
5 FIRE ALARM DEVICES
6 FIRE ALARM ROUTING EQUIPMENT
7 FAULT WARNING ROUTING EQUIPMENT
8 ALL
19:23
SHOW STATUS
ACTIVATED OUTPUTS
1 DOOR CONTROL UNITS
2 LOW LOCATION LIGHT UNITS
3 STANDARD CONTROL UNITS
4 OTHER OUTPUTS
5 FIRE ALARM DEVICES
6 FIRE ALARM ROUTING EQUIPMENT
7 FAULT WARNING ROUTING EQUIPMENT
8 ALL
19:23

Autronica BS-430 Specifications

General

Brand	Autronica
Model	BS-430
Category	Fire Alarms
Language	English