Autronica BS-430 User Manual

In the Event of a Fire Alarm -
with Alarm Delay
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 50
6. In the Event of a Fire Alarm -
with Alarm Delay
6.1 Indications - Fire Alarm with Alarm Delay
The following shows the indications on the Operator Panel in the
event of «Fire Alarm with Alarm Delay» within the operation zone of
the panel.
The internal buzzer is
activated.
Default pattern on the
sound:
1 sec. ON, 1 sec. OFF
A point set to Delayed Action (configurable) is sending an alarm signal from a Delayed Action
detection zone in a situation where Immediate Output Actioning has been disabled, i.e. the alarm
delay has been activated.
NOTE:
An alarm from a manual call-point is normally configured to give immediate actioning on the
alarm outputs even though Immediate Output Actioning has been disabled.
The text display indicates the detection zones in alarm state and their
location. In addition, the following information is shown by operating the
menu:
- detailed zonal information
- information on the specific points in alarm
The red Fire indicator is
blinking.
The Function Delayed
indicator has a steady
yellow light.
The Function Disabled
indicator has a steady
yellow light.
Note that the optional alarm presentation with zonal indication is used throughout the handbook.

Autronica BS-430 Specifications

General

Brand	Autronica
Model	BS-430
Category	Fire Alarms
Language	English