Name: Autronica BS-430
Brand: Autronica
Rating: 4 (1 reviews)

To Next Page

To Previous Page

In the Event of a Fire Alarm -

with Alarm Delay

Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,

Autronica Fire and Security AS

Page 51

6.2 Actions to be Taken - Fire Alarm with Alarm Delay

Step Actions to be taken Display Indication Audible Indication

Follow all precautions

described in the local

fire instructions, step by

step.

The internal buzzer on

the operator panel is

turned on.

Comments:

The red FIRE indicator starts to blink.

The FUNCTION DELAYED and FUNCTION DISABLED indicators have a

steady yellow light indicating that Immediate Output Actioning has been

disabled (manual operation in Menu Mode).

In this example, one point in a Delayed Action detection zone is signalling an

alarm.

The message «SHOW SUPPR. INFO» is shown in the lower right corner,

indicating that a disablement exists (Immediate Output Actioning has been

disabled). One or several fire warnings, tests or faults may also exist. To

view suppressed information, press Action Digit 4 (SHOW SUPPR. INFO).

To silence the internal

buzzer, press the black

Mute Panel button

The internal buzzer on

the operator panel is

turned off.

Press and

observe the zone(s) in

alarm state in the

display.

Comments: If you want to view detailed zonal/point information, go to step 4. If not, go

directly to step 8.

To select a zone (if there

are several zones),

scroll with the arrow

buttons

To view detailed zonal

information, press

To view points in alarm,

press Action Digit 1

(SHOW POINTS).

To go two steps

backwards, press the

black Close Window

button

twice.

Comments:

If you want to view detailed information for another zone, select the other

zone in step 4, repeat step 5, 6 and 7, then go to step 8. If not, go directly to

step 8.

If you want to prolong the delay, you can press Enter, then Action Digit 4

(PROLONG DELAY). The T1 period will terminate, and the T2 period will

start. If you do not want to prolong the delay period, go directly to step 9.

1*KITCHEN