Autronica BS-430 User Manual

In the Event of Faults
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 57
8. In the Event of Faults
8.1 Indications in the Event of Faults
The following shows the indications on the Operator Panel in the
event of Faults within the operation zone of the panel. Note that all
possible fault indications are shown in the presentation below.
•
Blinking light
Unaccepted fault warnings
exist.
• Steady light
All fault warnings are accepted.
The text display indicates the nature of the
fault.
Activated functions:
- The output line from the control and indication equipment is activated.
A fault is indicated by one of the components (fire detectors, external equipment or
other faults).
Yellow light on Fire Brig. Fault
indicator if a fault is detected on Fire
Alarm Routing Equipment.
The yellow System Fault
indicator is
steady if a system fault occurs.
Yellow light on Alarms Fault
indicator if a fault is detected on one
or more Fire Alarm Devices.
The green Power indicator is turned
off in case of loss of power.
Note that the optional fault presentation with zonal indication is used in this chapter.
Faults are presented with point indication as default.

Autronica BS-430 Specifications

General

Brand	Autronica
Model	BS-430
Category	Fire Alarms
Language	English