Axon Fleet 2 Installation Manual
Axon Enterprise, Inc. Page 15 of 39
Constant Power: The system needs 6V to 18V power, preferably provided directly from
battery with an in-line fuse.
• Below 6V the Fleet Power Units will see the ignition as OFF. The Status LED will blink
rapidly.
• Above 18V, the Fleet Power Unit will not draw power from the car. The Status LED
will blink rapidly.
Ignition Timer/Charge Guard Guidance:
If you are using an ignition timer or charge guard, Axon still recommends connecting the
Fleet Power Units to a constant voltage source, such as the car battery.
If the constant voltage source is the ignition timer, when it times out the Fleet Power Units
will stop communicating with cameras and cameras will shut down after 15 seconds.
The shutdown will also stop video offload unless ignition is turned back on. Recommended
timeout time is 1-2 hours
Ground:
The Maximum acceptable impedance to Static Chassis Ground is less than 0.25 Ohms
between pin 2 and chassis ground.
• Attempt to use dedicated ground buss bars or connect directly to the chassis.
• Do not use a floating ground. Ensure the ground path is not compromised by vehicle
vibration. Such as a ground path that runs through a mechanical connection to the
vehicle body/chassis that may not be firm/secured
• Avoid sharing ground connections with UHF/VHF Radios.
• Maintain at least 12 inches (30 cm) between system ground and any high current
loads, such as radios or other equipment that consumes more than a couple of
amps.
Pre-deployment Checks
Prior to installing the Axon Fleet system, review and confirm the following information:
• Mounting locations for Axon Fleet hardware, cameras, and cables for each type of
vehicle.
• Antenna placement on each type of vehicle.
To Next Page
Loading...
Need help?
General
