Axon Fleet 2 Installation Manual
Axon Enterprise, Inc. Page 26 of 39
• Place two ferrite clamps on the installed Fleet Power Unit to Camera cable (SKU
71085), one near where the cable connects to the Front Camera or Junction Box and
one near where the cable connects to the Fleet Power Unit.
If a Junction Box is not installed, place the ferrite clamp on the end of the cable near
where it plugs into the Front Camera and one near where the cable connects to the
Fleet Power Unit.
DO NOT place the clamps on the camera’s cable. The clamps must only be placed
the Fleet Power Unit to Camera cable (SKU 71085).
• If your radios operate in the 150 – 160 MHz bands, axon recommends running the
Fleet Power Unit to Camera cable (SKU 71085) through the ferrite clamp 2 times.
Note that running the Fleet Power Unit to Camera cable (SKU 71085) 2 times
can be very tight and puts a strain on the clamp clasp. Axon recommend
adding tape around the clamp to hold it closed.
DO NOT run a shielded Fleet Power Unit to Camera cable (SKU 71085)
through the clamp 2 times.
Wiring the Axon Fleet Power Unit
Be sure to observe appropriate safety protocols while working with vehicle electronics.
Axon Fleet Power Unit to Car
1. Confirm the mounting location.
2. Locate the power unit to vehicle cable (SKU 71100) and appropriately route the wires
from the vehicle to the location of the power unit.
Notes:
• It is not necessary to affix the power unit at this point. Depending on mounting
location, affixing the unit prematurely may make it difficult to attach wires.
• Vehicle power sources should be accessed as determined by the vehicle
manufacturer.
After the wiring harness is tied into the vehicles electrical system, proceed to step 3,
using the opposite end of the harness.
3. Once the appropriate power wires have been run to the power unit mounting location
strip no more than 0.25″ (6.35 mm) of insulation from each of the wires.
To Next Page
Loading...
Need help?
General
