Axon Fleet 2 Installation Manual
Axon Enterprise, Inc. Page 36 of 39
The cable exiting the charging dock has two wires: Red for 12VDC power and Black for GND.
The wires come with factory-installed butt-splice terminals.
This cable is 18 feet (6 m) in length and contains the following wires:
18 AWG – Black
18 AWG – Red – 12V power, 2 amp fuse
Two Axon RapidLock mounts
Optionally, your agency can also purchase:
• Additional Axon Fleet 2 wireless microphones
• AB2 Sync cables (for charging from USB)
• Axon Dock with bays for Axon Body 2 cameras, for in station charging of the wireless
microphones
Additional Tools
The following is a list of required and recommended tools to install the Axon Fleet 2 wireless
microphone junction box and in-car charging dock.
• Alcohol wipes and paper towels
• 3M Silane Glass Treatment AP 115
• Wire cutters and crimper (Klein Tools products are recommended)
• Cable ties for holding cables in place
• Metal or nylon fishing tape for running wires through channels
• #2 Phillips screwdriver – if installing the in-car charging dock to the vehicle partition
or on a carpeted area.
To Next Page
Loading...
Need help?
General
