34
To adjust the noise gate settings for a channel:
1 On the appliance Web UI’s main page, select DSP.
2 Select the Menu button for the channel.
3 From the drop-down menu, select Noise Gate.
4 Adjust the following settings as needed:
Figure 15. Noise Gate Settings
Note: If you want to return to the factory settings, select the Reset icon that appears in
the right corner.
Table 15. Noise Gate Settings
Enable Enables or disables the noise gate DSP effect for this chan-
nel.
Threshold Sets the minimum threshold level that the signal must
re
ach for the noise gate to “open,” allowing the signal to
be sent to the output channel.
Threshold range is -135 to +21 dB.
To Next Page
Loading...
Need help?
General
